Menu
Your Cart

2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi

2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
-25 %
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
2 relay module 5V 12V optocoupler protective tape applied to UNO Microprocessor board Raspberry Pi
$0.89
$1.18
  • Stock: In Stock
  • Model:
  • Weight: 0.06kg

Available Options

Module parameters:
  • 1. Size: 50.5mm (length) * 38.5mm (Width) * 18.5 (high)
  • 2. Weight: 31G
  • 3.PCB Color: Black
  • 4. The board is surrounded by 4 fixed screw holes, the hole diameter is 3.1mm, which is convenient to mount and fix
  • 5. Relay uses a high quality Songle relay, single knife double throw.A common end, a normally closed end
  • 6. Optocouplex isolation, good anti-interference
  • 7. Low level insection, high level release.The status indicator is on the laminated time, and the status indicator is released.
  • 8.VCC is a system power supply, JD_VCC is a relay power source.Plug in jumper cap

Electrical parameters:

  • Power supply voltage: 5VDC, 12VDC
  • Current: greater than 100mA
  • Load: 250V 10A exchange or 30V 10A DC

Wiring description:

  1. VCC: System power supply positive
  2. GND: system power supply negative
  3. IN1 - IN2: Relay control port (Do not reverse, causing the module burning) We do not give back.

Shipping list:

2-way photo optocoupler secondary module

23

22

Write a review

Note: HTML is not translated!
Bad Good